1918
Power on
1) Power switch:
The power switch (which is red) is located on the battery pack,
on the left side of the Blipper frame.
The power switch - when flipped to the left (the ON position) - will enable all other
control mechanisms to be used (i.e. ignition and accelerator lever).
Before using the product, the power switch must be in the ON position FIRST,
before using the ignition key to power on the motor.
When the product is ready to be powered off, ensure the ignition is turned off FIRST,
before flipping the power switch to the right (the OFF position).
ATTENTION:
DURING RIDING: If the power switch is accidentally flipped to the OFF position while
the rider is riding the product (with the ignition key still in the ON position), the motor
will automatically shut off.
DURING CHARGING: The power switch must be ON during charging.
(When the product is NOT charging and NOT in use, the power switch must be OFF.)
DURING STORAGE: The power switch must be OFF, if storing the product away.
Power on (continued)
2) Ignition key:
The ignition key should be in the parent or adult supervisor’s possession at all times,
unless the product is in use (under parental or adult supervision if the rider is below the
age of an adult as defined by law).
The ignition key is used to turn on the motor by fully inserting it inside the ignition and
turning the key to the right. (The ignition is located on top of the battery pack.)
The ignition key must stay in the ignition while the product is in use.
The ignition key will NOT turn on the motor unless the power switch is ON first.
The ignition key must be removed from the ignition while the product is not in use.
To Next Page
Loading...
Need help?
General
