1514
Assembly
Assembly must be conducted by an adult.
DO NOT ALLOW CHILDREN to conduct assembly, as there may be small parts,
sharp edges / sharp points, and packaging material that can present as hazardous.
Ensure proper disposal (and/or recycling, per local laws) of all interior packaging material,
so that they are OUT OF REACH from both children and pets.
It is recommended that you KEEP the original packaging box, in the event that the Blipper
needs to be stored away.
Step one: Installing the kickstand
• Locate the kickstand, 5 mm allen wrench, and 10 mm wrench.
• Ensure the frame is lying flat on a smooth and even surface, with the left side facing up.
• Locate the bottom edge of the frame (where the two holes are) right next to the rear
wheel. This is the frame bracket where the kickstand will be installed.
•
Align the top of the kickstand (where the two holes are) accordingly.
•
Pass each screw through the aligned holes.
•
Thread each nut onto each screw from the back of the frame bracket, and fully
tighten each nut using the 10 mm wrench.
•
Use the 5 mm allen wrench to fully tighten the screws from the front (at the top of
the kickstand).
•
Ensure that the kickstand is fully and tightly installed by pulling on it. There should
be no looseness.
•
To use the kickstand, prop the product up to an upright position with both hands,
and ensure the kickstand is pointed towards the ground. (If it’s not, use your foot to
push the kickstand lever until it’s pointed towards the ground.) You can now gradually
lean the product onto the kickstand. The kickstand should fully support the product’s
weight when the product is not in use.
• Remove both pre-installed screws and nuts from the frame bracket.
To Next Page
Loading...
Need help?
General
