!Caution
Free-standing appliances and appliances with open combustion do not have
a control hatch. If you have a free-standing appliance or appliance with open
combustion, please follow the instructions in the installation manual for your
appliance.
➠
Pick up the receiver.
➠
Slide the cover o.
➠
Remove and place the 4 penlite (AA type) batteries.
!Caution
- Avoid a short circuit between the batteries and metal objects/parts;
- Observe the “+” and “-” poles of the batteries and the holder;
- Use alkaline batteries;
- Batteries are regarded as “small chemical waste” and may therefore not be
disposed with the household rubbish.
➠
Slide back the cover.
➠
Place the receiver (V) as indicated in g. 1
!Caution
- Do not place the antenna (N) too close to the ignition cable and/or metal parts:
make sure the antenna is pointing upwards (for the correct position, see g. 1);
- Make sure the ignition cable is not running over/alongside metal parts: this
will weaken the spark;
- Do not lay the ignition cable over the receiver: this could damage the receiver.
1
To Next Page
Loading...
