Page 4 For technical questions, please call 1-888-866-5797. Item 58033
Areas of use
1. This pump is designed to pump water only.
2. This pump is designed to be used for:
General purpose removal or transfer of clear water.
3. This pump should NOT be used for:
Continuous run, fountain/pond water features.
Removing water from swimming pools or
spas. Septic or sewage systems.
4. This pump can also be used to transfer water
(e.g., household, farming, plumbing).
Installation Instructions
1. Attach hose to Pump intake port. Attach
second hose to Pump discharge port.
2. Position Pump on solid surface so that
both hoses are free from kinks. Plug Power
Cord into GFCI protected outlet.
GFCI-
Protected
Receptacle
Figure A: GFCI Plug
3. Place unused end of intake hose in water to
be transferred. Place unused end of discharge
hose as needed to direct the water discharge
at least 3 feet away from the source.
Figure B: Pump Position
Operation
After reading these instructions, consider the following points before starting the pump:
1. Verify that the discharge pipe is properly connected.
2. Verify that the electrical connection
is 120 VAC, 60 Hz.
3. Verify that the electrical socket is GFCI
protected and in good condition. Test
GFCI protected outlet before use.
4. Verify that water and moisture cannot
get near the power supply socket.
5. Verify that the pump is installed so
as to prevent running dry.
Maintenance
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Unplug the Pump from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
If the pump is moved during operation, flush it out with clean water after every use.
To Next Page
Loading...
