Page 4 For technical questions, please call 1-888-866-5797. Item 63318 63319
Installation Instructions
1. Place pump in water.
Danger! Do not use an extension cord with this
pump. Keep plug dry and secured away from water.
2. Attach one end of a discharge hose to the
discharge port. Place the other end as needed
to direct the water discharge at least 3 feet
away from the source. Slope the discharge
hose downward, away from the source.
Discharge
Hose
Figure A: Pump Position
3. Plug Power Cord into GFCI protected outlet.
GFCI-
Protected
Receptacle
Figure B: GFCI Plug
Operation
After reading these instructions, consider the following points before starting the pump:
1. Verify that the pump rests on the floor of the basin,
if it is not suspended by the handle.
2. Verify that the discharge pipe is properly connected.
3. Verify that the electrical connection
is 120 VAC, 60 Hz.
4. Verify that the electrical socket is GFCI
protected and in good condition. Test
GFCI protected outlet before use.
5. Verify that water and moisture cannot
get near the power supply socket.
6. Verify that the pump is installed so
as to prevent running dry.
NOTE: The Pump will not start without 1" of water.
NOTE: The Pump will remove water down to 1/4″.
Unplug the Pump once 1/4″ water level is reached.
To Next Page
Loading...
