OPERATION:
Turn on/off the unit:
Press on/off button to turn on the unit. When the unit is on. Press and hold it for
2 seconds to turn off the unit.
Sound and setting adjustment:
Shortly press VOL knob for the audio menu:
BAS->TRE->BAL->FAD->EQ->LOUD
Press and hold VOL knob for 2 seconds for the setting menu:
SUB-V(20~0) -> SW(80HZ/120HZ/160HZ)-> CLK HH -> CLK MM ->
CT(indep/sync) ->CLOCK(12/24)->
BEEP(on/off)->P_VOL(17)->AREA(USA/EUR)->DX/LOC->ST/MONO
In each item rotate the VOL knob to set them.
EQ: To select the preset EQ as below: FLAT->POP->ROCK->CLAS->EQ OFF.
LOUD (on/off): Turn on/off the loudness function.
SUB-V (20~0): Subwoofer volume adjustment.
SW (160Hz/120Hz/80Hz): Subwoofer Low Pass Frequency selection.
CLK HH/CLK MM: To adjust the hours and minutes of the clock.
CT (INDEP/SYNC):
CT INDEP: The clock works independently.
CT SYNC: The clock will be synchronized to the received RDS station’s time.
Note: When the time was set by manual. The CT will back to INDEP
mode automatically.
CLOCK 24/12: Setting the time to 24H or 12H format.
BEEP (on/off): Turn on/off the beep sound.
P-VOL (Preset VOL): Setting the power on volume. If the volume at shutdown is
small than the P-VOL value. Next time turn on the unit, the volume will be
maintained at shutdown volume. If the volume at shutdown is greater than the
P-VOL value. Next time turn on the unit the volume will be restored to the
P-VOL value.
AREA (USA/EUR): Choose America or Europe region frequency.
DX/LOC (Distance/Local):
LOC: Receive the strong signal station only in seek station.
DX: Receive strong and weak signal station in seek the station.
STEREO/MONO:
STEREO: Receive FM stereo signal.
MONO: Change FM stereo to monochrome. It can reduce the noise when the
signal is weak.
Display the clock or information
Shortly press CLK button to show the clock or information.
Reset the unit
Press and hold dk button for 5 seconds to reset the unit.
Note: When RESET function is activated, all the memories will be lost.
MUTE on/off operation
In RADIO/AUX source press d button for MUTE on/off function. In USB/BT
source press dk button for Pause/Play function.
Radio Operation
Receive a radio station
Press SRC button to select RADIO mode. Then press BAND button to select a
band. Shortly press e/f button to receive the desired radio station. Press
and hold e/f button for manual tuning the frequency.
Manually store station
Receiving a desired station. Press and hold the PRESETS button for 2 seconds.
It shows “SAVE P1”. Rotating VOL knob to select P1~6 then press VOL
button. The station will be saved.
Listening to the memory station
Shortly press the PRESETS button then rotating VOL knob to select the presets
1-6 of current band.
Auto store station
Press and hold BAND button to auto store stations to numeric buttons 1-6 of
band 1~3.
USB Operation
When an USB driver inserted to the unit, the unit will play the MP3/WMA file
automatically. If an USB drive is already inserted in the unit. Keep pressing SRC
button shortly until the USB mode display appears.
Select file
Press e/f button to skip to next/previous file. Hold e/f button to fast
forward or fast reverse.
Play/Pause
Press dk button to pause/play the playing.
DIR+/DIR- function
Shortly press PRESETS button for 1 time. It shows DIR-SCH. Rotating VOL
knob to select another directory to play.
MRX1
To Next Page
Loading...
General