DSC Envoy NT9010 - Turning On Your System (Stay Mode); Quick Arming Options

12
Turning On
Your System
While You Are
At Home (Stay
Mode)
Use the Stay mode when you want to stay on the premises, and also want to pre-
vent unauthorized entry from outside. The system will only turn on the perimeter
zones (e.g. door and window contacts), and will leave the interior zones off (e.g.
motion detectors) so that you will be free to move around inside.
1. Check that your system is ready (green Ready light is ON)
2. Enter your [access code]. As you enter each digit, the keypad sounder beeps.
If you entered the access code incorrectly, the keypad sounder will buzz steadily
for two seconds. Re-enter your access code correctly.
When you enter a valid access code:
• The keypad sounds fast beeps.
• The red (Armed) light turns ON.
• The exit time begins and the keypad beeps once every second. The keypad
will beep quickly for the last 10 seconds of the exit time.
3. DO NOT leave through the entry/exit door. This tells the system that you are not
leaving, and the system automatically turns off the interior zones.
At the end of the exit time, all keypad lights, except the red (Armed) and yellow
(System) lights, turn OFF. The system is now on.
Re-activate bypassed zones
To turn on the rest of the system when it is in Stay mode:
1. Press . The interior zones are now on.
NOTE:
When you have turned on the interior zones, you will not be able to
enter areas protected by motion detectors, or open doors and windows. To
access these areas, you must enter your [access code] and turn off the sys-
tem.
Stay Button
You may also be able to quickly Stay arm your system using the “Stay” function
button on your keypad.
If your installer has programmed this button
, press and
hold it for two seconds to turn your system on in Stay mode.
Turning On
Your System
With No
Access Code
(Quick Arm)
Your installer will tell you if the Quick Arm method is enabled on your system.
Using the following method, you can quickly turn on your system without having
to enter an access code.
1. Check that the system is ready (green Ready light is ON)
2. Press .
• The keypad sounds fast beeps.
• The red (Armed) light turns ON.
• The exit time begins and the keypad beeps once every second until the
end of the exit time.
3. Go out through the entry/exit door. The system will be in Away mode. If you do
not exit, the system will be in Stay mode.
1
*
*
0