DSC Envoy NT9010 - Page 2

Quick Reference Guide
The following chart lists the basic functions of your system, and the keys to press for each
function. Refer to the listed page number for more information.
NOTE: Some functions may not be available on your system. Ask your installer for
more information.
To Perform This Function: Enter: Page:
Turn on system (Away): ..................... [access code], leave through entry/exit door 9
OR press (if enabled)
Turn on system (Stay):........................ [access code], do not leave premises 12
OR press (if enabled)
Turn off system:................................. [access code] 10
Turn on system (No Entry Time): ........ [access code] 13
Turn on system (Quick, if enabled):.... (from Ready state) 12
Turn on rest of system (if Stay armed): OR press (if enabled) 12
Exit premises when system on: .......... OR press (if enabled) 14
Turn off zones (Bypass): ..................... [two-digit zone number(s)], to exit 18
Test system ........................................ [master code] 20
Send Fire message: ............................ (press & hold for 2 seconds, if enabled) 17
Send Auxiliary message: .................... (press & hold for 2 seconds, if enabled) 17
*Send Medical message: ................... (press & hold for 2 seconds, if enabled) 17
Send Panic message: ......................... (press & hold for 2 seconds, if enabled) 17
Silence fire alarm: .............................. [access code] 15
Silence intrusion alarm: ..................... [access code] 16
Turn door chime on/off: ...................... to toggle on or off 22
OR press (if enabled)
Check alarm memory: ....................... 16
Check troubles .................................. 19
Set time and date:............................. [master code]
*
If available
Away
Stay
*
9
*
0
1
*
Away
*
0
Exit
1
*
#
6
*
4
4
*
Chime
3
*
2
*
6
*
1