14
• One-Time Use Codes are used to allow infrequent users of the system,
such as service personnel, to arm the system. When the system is armed
using a One-Time Use Code, the code will be erased once the Exit Delay
expires; after this time, the code may not be used again. If the One-Time
Use Code is entered before the Exit Delay expires, arming of the system
will be cancelled; the One-Time Use Code may then be entered again
later to arm the system.
• Log Only Codes are used strictly for logging to the event buffer. The
system master can log the time, date and location which they were at with
the Log Only codes. To enable this code type, enable just door strike or
disable all options.
Note: Do not program access codes such as 1111 or 1234 which can
be easily guessed and will compromise the security of your system.
• Escort 4580 Access allows the user to access the Escort 4580 (Voice
Prompting Module) via the in house telephone or remotely through a
telephone. The user will have the same abilities through the VPM-2 as they
would through a regular keypad.
Note: Do not program One-Time Use Codes without arming or disarming
enabled.
• Global Access allows the access code to be used on global keypads.
Disabling this toggle option for any access code will inhibit the code from
being used on any global keypad.
• Partition Selection Menu
brings up the partition selection menu when a
multi-partition access code is entered on a partition keypad. When this
option is disabled, multi-partition access codes will function as a single
partition access code for the partitions the access code is enabled on.
To Next Page
Loading...
Need help?
General
