Canadian
Department
of
Communications
Notice
NOTICE:
The
Canadian Department of Communications label identifies certified
equipment.
This
certification
means
that
the
equipment
meets
certain
telecommunications network protective, operational and safety requirements. The
Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company.
The
equipment
must also be installed using an acceptable method of connection.
In
some cases, the
company's inside wiring associated with a single line individual service may be
extended by means of certified connector assembly (telephone extension cord).
The
customer should be aware that compliance with the above conditions may not
prevent degradation of service
in
some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made by
the
user
to
this
equipment,
or
equipment
malfunctions,
may
give
the
telecommunications company cause to request the user to disconnect the equipment.
User should ensure for their own protection that the electrical ground connections of
the power utility, telephone lines and internal metallic water pipe system, if present,
are connected together. This precaution may be particularly important
in
rural areas.
CAUTION: Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electrician, as
appropriate.
The LoadNumber(LN) assigned to each terminal device denotes the percentage of
the total load to be connected to a telephone loop which is used by the device, to
prevent overloading. The termination on a loop may consist of any combination of
devices subject only to the requirement that the total of the Load Numbers of all the
devices does not exceed 100.
The
Load Number of this unit is
2.
,.,
SYSTEM REFERENCE
ZONE
2
3
4
PROTECTED AREA
AUX
________
_
ZONE
TYPE
KEYPAD ZONE [1), [3)
_______________
_
KEYPAD ZONE [4), [6)
_______________
_
KEYPAD
ZONE[*),[#)
_______________
_
MASTER
CODE NUMBER [1]:
______________
_
PROGRAMMED ACCESS CODE NUMBERS:
[2)
------
[3)
_______
[4]
------
SYSTEM
ENTRY
TIME
___
SECONDS
SYSTEM
EXIT
TIME
SECONDS
MONITORING
STATION
INFORMATION:
ACCOUNT#:
___________
Phone:
_______
_
FOR SERVICE:
CALL:
_______________
Phone:
_______
_
NOTES:
1
To Next Page
Loading...
Need help?
General
