DSC PC2550 - Page 27

Note: In sections [01] through [13], do not enter any data in sections that are not used.
[01] 1st Phone Number Page 16
• Be sure to enter [#] to end number
• Enter [0] for digit “0” in phone number
[02] 1st Account Code Page 17
• For 3 digit code enter [0] for last digit
• Enter [
✱1✱] (HEX A) for digit “0” in account code
i.e. Account code 103 would be [1]+[
✱1✱]+[3]+[0].
[03] 2nd Phone Number Page 17
[04] 2nd Account Code Page 17
[05] Alarm Reporting Codes Zones 1 to 8 Page 17
Zone 1 Alarm Zone 5 Alarm
Zone 2 Alarm Zone 6 Alarm
Zone 3 Alarm Zone 7 Alarm
Zone 4 Alarm Zone 8 Alarm
[06] Restoral Reporting Codes Zones 1 to 8 Page 17
Zone 1 Restoral Zone 5 Restoral
Zone 2 Restoral Zone 6 Restoral
Zone 3 Restoral Zone 7 Restoral
Zone 4 Restoral Zone 8 Restoral
[07] Reporting Codes for Closing (Arming) via Access Codes 1 to 8 Page 17
Access Code 1 Access Code 6
Access Code 2 Access Code 7
Access Code 3 Access Code 8
Access Code 4 Partial Closing Code
Access Code 5
[08] Reporting Codes for Closing (Arming) via Access Codes 9 to 16 Page 18
Access Code 9 Access Code 14
Access Code 10 Access Code 15
Access Code 11 Access Code 16
Access Code 12 Auto-arm Abort Code
Access Code 13
PROGRAMMING
WORK SHEETS
PC2550 Version 1.2
27
• For single digit reporting codes, enter [0] as 2nd digit
• Enter [✱1✱] (HEX A) to transmit a “0”.
(A “0” digit is 10 pulses.)
Note: For UL installations, the second phone number
must not be activated as the total number of dialing
attempts will be greater than 10.
WWW.DIYALARMFORUM.COM