EasyManua.ls Logo

DSC PC5015 - Page 44

DSC PC5015
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41
is enabled, the programmed Time of Day Timer [371] will not apply.
Test Transmission Interval in Days: A test transmission will be sent to the monitoring station at the
programmed time of day in Section [371] and at the Interval programmed in Section [370].
4.1600Hz/Standard Handshake: With this option enabled the communicator will respond to 1600Hz
handshakes when using the reporting Communication Formats 1 and 2 only. The Standard Handshake
is 1400Hz or 2300Hz.
5.ID Tone Enabled: With ID Tone Enabled the panel will pulse a tone on the telephone line to indicate
that the panel is on the line.
6.2100Hz/1300Hz: Selectes the frequency of the ID tone that is pulsed on the line. Contact your local
telephone company to confirm which setting should be used.
7. One Time 1-Hr User enabled DLS Window: When the User enables the DLS Window through [][6][Master
Code][5] the panel will answer an incoming call for Downloading within the 1-Hr time Window without having
to have Downloading Answer Enabled in Section [401]. After a successful Download has been completed
the Window will be closed and a call will not be answered unless Downloading Answer is Enabled.
Full 6-Hr User enabled DLS Window: When the User enables the DLS Window through [][6][Master
Code][5] the panel will answer an incoming call for Downloading within the 6-Hr window. The window
will remain open for the full 6 hours.
8.Bell on FTC when Armed: When enabled, an FTC (Failure to Communicate) on either Partition during the
armed period will sound an Audible Alarm for the length of Bell time-out or until the system is disarmed.
FTC Trouble only when Armed: If a Failure to Communicate trouble is generated while the panel is
armed only the keypad buzzer will sound trouble beeps every 10 seconds until a key is pressed.
5.31.4 [703] Delay Between Dialing Attempts
The Delay Between Dialing Attempts timer adds a delay before the next call is dialed (after step d in the
Force Dialing section, or after a busy tone is detected in the Busy Tone Detection section).
P R O G R A M D E S C R I P T I O N S

Table of Contents

Related product manuals