12
3.5 Viewing Programming
LED and LCD5501Z Keypads
Any programming section can be viewed from an LED or
LCD5501Z keypad. When a programming section is entered, the
keypad will immediately display the first digit of information pro-
grammed in that section.
The keypad displays the information using a binary format,
according to the following chart:
See Hex data
entry instructions
Press any of the Emergency Keys (Fire, Auxiliary or Panic) to
advance to the next digit.
When all the digits in a section have been viewed, the panel will
exit the section: the Ready Light will turn OFF, and the Armed
light will turn ON, waiting for the next three-digit programming
section number to be entered.
Press the [#] key to exit the section
LCD Keypad
When a programming section is entered, the keypad will immedi-
ately display all the information programmed in that section. Use
the arrow keys (< >) to scroll through the data being displayed.
To exit the section, scroll past the end of the data displayed, or
press the [#] key.
To Next Page
Loading...
