DSC Power 864 - Section 1: Introduction; How Your System Works; Important Notices and Safety

4
PC5700 Fire Module
This is a zone expansion module with four general purpose zone
inputs, two Class A supervisory waterflow zone inputs, ground
fault detection and dual-supervised telephone line inputs.
PC5720 Fire Module
This is a zone expansion fire module that can be used for ULC-
listed non-residential fire applications. The PC5720 can also be
used as an interface between the control panel and either a serial
printer or a DVAC communications network.
NOTE: The PC5700 and PC5720 each enroll as two expander
modules and use up two supervisory slots.
NOTE: Do not mix PC5700 and PC5720 v1.x and lower mod-
ules with PC5108 v2.0 and higher modules on the same sys-
tem.
Cabinets
Several different cabinets are available for the PC5020 modules.
They are as follows:
• PC5003C Main Control Cabinet for the PC5020 main panel.
Dimensions 288mm x 298mm x 78mm / 11.3” x 11.7” x 3”
approximately.
• PC5002C Cabinet to house the PC5204 Power Supply Output
Module. Dimensions 213mm x 235mm x 78mm / 8.4” x
9.25” x 3” approximately.
• PC5004C Cabinet to house the Escort5580 Module and
PC5400 Printer Module. Dimensions 229mm x 178mm x
65mm / 9” x 7” x 2.6” approximately.
• PC5001C Cabinet to house the PC5108 Zone Expander Mod-
ule and the PC5208 Eight Low Current Output Module.
Dimensions 153mm x 122mm x 38mm / 6” x 4.8” x 1.5”
approximately.
• PC5001CP Plastic Cabinet to house the PC5108 Zone
Expander Module and the PC5208 Eight Low Current Output
Module. Dimensions 146mm x 105mm x 25.5mm / 5.75” x
4.2” x 1” approximately.
Backplates
There are two different backplates available for keypads to
mount an Audio Station next to a keypad:
PC55BP1 Backplate
Use this backplate when mounting an
Audio Station next to a keypad. Dimen-
sions 208mm x 115mm x 18mm / 8.2”
x 4.5” x 0.25” approximately.
PC55BP2 Backplate
Use this backplate when mounting an
Audio Station next to a keypad. In
addition the backplate will allow you to
mount a PC5108 Zone Expander Mod-
ule or the PC5208 Eight Low Current
Output Module. Dimensions 208mm x
115mm x 18mm / 8.2” x 4.5” x 0.7”
approximately.
1.5 Out of the Box
Check that the following equipment is included in your system:
• one PC5020 main control cabinet
• one PC5020 circuit board
• one LCD5501Z / LCD5500Z keypad
• one set of manuals:
- one Installation Manual
- one Programming Worksheets
- one User’s Guide (for the end-user)
• one hardware pack consisting of:
- five plastic circuit-board standoffs
- seventeen 5600Ω resistors
- one 1000Ω resistor