Connections:
The Omnicabsim MINI features:
- ¼” Input Jack: Connect here the output from your pedalboard/ amp fx send, or just the
instrument (for best results, a high output instrument, or a preamp is recommended)
- ¼” Output Jack: This output can be set to carry the Cabinet simulator signal or the
Bypass signal.
- XLR Output: Active balanced output for direct inputs. This output will only carry the
cabinet simulator signal (unless the pedal is bypassed).
- DC Input: As stated previously, use only a regulated 9V to 12V DC, center negative,
2.5mm jack power supply.
To Next Page
Loading...