DSR INC-700A - User Manual

Questions and Answers

M
Maria WardAug 11, 2025
What to do if my DSR INC-700A shows 0.0 volts?
- A
  acostatraceyAug 11, 2025
  If your DSR Battery Charger display reads 0.0 volts, it could be due to several reasons. First, check the clamps to ensure they are making a solid connection to the battery and frame, and that the connection points are clean. Rocking the clamps back and forth might help improve the connection. If that doesn't work, unplug the charger and reverse the clips. Finally, the battery itself might be defective and unable to accept a charge, so consider having it checked.
B
Becky AveryAug 18, 2025
Why has my DSR INC-700A Battery Charger shut down?
- C
  Cathy TaylorAug 18, 2025
  Your DSR Battery Charger may have shut down because it got too hot. The charger has thermal protection that will cause it to shut down if it overheats. To resolve this, unplug the AC cord and allow the charger to cool down. Also, ensure that nothing is blocking the airflow to the fans, and clean them as described in the maintenance instructions.
T
Tyler LeeAug 25, 2025
How to fix a rattling noise in my DSR Battery Charger cooling fan?
- N
  nkellyAug 25, 2025
  A rattling noise in the cooling fan of your DSR Battery Charger is likely due to a buildup of dirt and grime causing it to be unbalanced. To fix this, blow the dirt and grime off the fan blades using compressed air as described in the MAINTENANCE INSTRUCTIONS.
M
Mark HansonSep 4, 2025
How to troubleshoot a DSR Battery Charger with no display and no LED lights?
- M
  Michael CooperSep 4, 2025
  If your DSR Battery Charger has no display and the LEDs are not lit, the most likely cause is that the charger is not plugged in or there is no power at the receptacle. Plug the charger into an AC outlet. Check for an open fuse or circuit breaker supplying the AC outlet.
J
James PerryNov 28, 2025
Why does my DSR INC-700A Battery Charger display a lower AMPS reading than the selected charge rate?
- S
  sheilapooleDec 1, 2025
  If the AMPS reading on your DSR Battery Charger display is lower than the selected charge rate when charging a discharged battery, it could be due to a few reasons. The extension cord might be too long or have too small a wire gauge. Alternatively, the battery might have a weak cell or a sulfated plate. It's also possible that the charger has reached the maximum voltage and is reducing the current, which is normal. If using an extension cord, try a shorter or heavier gauge one. A sulfated battery may eventually take a normal charge if left connected. If the battery doesn't charge, have it checked. If the charger reached the maximum voltage and is reducing the current, this is a normal condition. Continue to charge the battery and see BATTERY PERCENT AND CHARGE TIME section, CHARGE RATE sub...