DT Research DT390i User Manual

DT390i
ENGLISH
6
7
ENGLISH
Buon Management
Where supported by soware, many of the hard buons on the DT390i are
programmable to perform a funcon of the user
’
s choice. The excepon is the Power
Buon and the SAS Buon. To acvate the buon re-assignment applicaon, invoke the
Buon Manager applicaon, e.g., in Windows XP Embedded
.
Brightness Control
Where supported by device firmware and soware, a hard buon may be engaged to
manipulate the display brightness. Press the System Ulity Menu buon (Buon 7) on
the front of the DT390i. The System screen will display a Brightness control secon with
up and down arrows that can be acvated with the stylus.
Baery and Power Management
The DT390i is equipped with an internal 3760mAh Li-Ion baery pack that is capable of
supporng approximately 3 - 4 hours of connuous operaon. With the internal baery
and an external baery pack that clips (hot-pluggable) onto the back of the device,
the maximum period of connuous operaon will be approximately 6 - 8 hours. The
period between baery recharges can be significantly lengthened by pung the device
into Standby mode through the
Power Buon (see Buons Funcon Table) whenever
the device is not in use. Depending on the operang soware, the DT390i may also be
configured to enter various power-saving modes via the Power Buon or through med
entry.
Full Slot Smart Card Reader
The DT390i comes with a full slot smart card reader.
Remove the rubber and insert a card (Picture 1).•
Use the stylus to pull the metal pull and then rem
ove the card (Picture 2).•
USING THE DT390i
Memory & Storage Configuraon
The DT390i is available with 2GB memory configuraon. Storage opons currently range
from 2GB to 32GB flash memory.
Peripherals Support
Through its USB port, the DT390i supports a wide range of USB-based peripherals. These
peripherals are applicable for soware installaon, applicaons storage, data storage,
docking or soware rec
overy and update.
The DT390i is complemented by an oponal Desktop Cradle or Wall/ Vehicle Mount
Cradle for support, pass-through charging, and connecon to a range of USB peripherals,
including keyboard and mouse. The Cradles offer the following interfaces: a DC-in port
for the AC-DC adapter, an Ethernet port, a VGA output and USB ports. Always seat the
DT390i securely onto the cradle. The cradle
must be powered by the AC-DC adapter
for the Ethernet and USB ports to funcon. The baery packs on the DT390i may be
recharged by connecng the AC-DC adapter directly to the DC-in port on the DT390i or
through the DC-in port on the Cradle while the DT390i is docked.
For More Support
Users can download the Soware Ulity and Modules Operaon Guides from the DT
Research website.
If the DT390i comes wi
th a 3G module, please contact your product and/or service
provider for the SIM Card Slot Locaon and Inseron Guide.
(Picture 1) (Picture 2)

DT Research DT390i Specifications

General

Brand	DT Research
Model	DT390i
Category	Tablet
Language	English