DTE D600 - EMC - Declaration of Conformity

19
11. EMC - Declaration of conformity
The device has been tested and homologated in accordance with EN
60601-1-2 for EMC. This does not guarantee in any way that this device
will not be effected by electromagnetic interference Avoid using the
device in high electromagnetic environment.
Guidance and manufacturer’s declaration - electromagnetic emissions
The models D600, D600 LED are intended for use in the electromagnetic
environment specied below. The customer or the user of the models D600, D600
LED should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1
The models D600, D600 LED use RF energy
only for its internal function. Therefore, its RF
emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
RF emissions
CISPR11
Class B
The models D600, D600 LED are suitable
for used in domestic establishment and in
establishment directly connected to a low
voltage power supply network which supplies
buildings used for domestic purposes.
Harmonic
emissions lEC
61000-3-2
Class A
Voltage uctuations
/ flicker emissions
lEC 61000-3-3
Complies
Guidance & Declaration — electromagnetic immunity
The models D600, D600 LED are intended for use in the electromagnetic
environment specied below. The customer or the user of the models D600, D600
LED should assure that It is used in such an environment.
Immunity test
IEC 60601 test
level
Compliance
level
Electromagnetic
environment - guidance
Electrostatic
discharge
(ESD)
lEC 61000-4-2
±8 kV contact
±2 kV, ±4 kV, ±8
kV, ±15 kV air
±8 kV contact ±2
kV, ±4 kV, ±8 kV,
±15 kV air
Floors should be wood,
concrete or ceramic tile.
If oors are covered with
synthetic material, the
relative humidity should be
at least 30 %.