5
2.2 Cleaning mode
It is suggested to wash and disinfect the water pipe after scaling everyday.
The “Cleaning mode” can wash and disinfect the water pipe, reducing the crystal
substance and bacterias in water pipe.
Operation:
1.Put distilled water or mineral substance into water tank.
2.Press the automatically water supply button and outside water
button at the same time (1s) to start the “Cleaning mode” after buzzer
beeps. The button of automatic water supply mode would flashes and
others buttons will go out.
3.Link the connector and the handpiece with the drainage device.
4.Step the pedal, the device would start self-cleaning. After that the
pedal could be loosen.
5.After cleaning for 30s, the device would stop self-cleaning. Or
u can stop by step the pedal again or press the automatic water supply
button.
6.After cleaning, press the automatically water supply button and
outside water button at the same time (1s) to exit the “Cleaning mode”
after buzzer beeps.
3. Maintenance
3.1 Troubleshooting
Fault Possible cause Solutions
The scaling tip doesn't
vibrate and there is no
water owing out when
stepping on the foot
switch.
The power plug is in loose
contact.
Make the plug insert to
the socket well.
The foot switch is in loose
contact.
Insert the foot switch to
its socket tightly.
The fuse in the main unit is
broken.
Contact our dealers or us.
To Next Page
Loading...
