4
5.2 Fix the light hood on the bottom of the optical ber.
5.3 Uninstall the LED, just reverse the procedure above.
5.4 Battery replacement method: open the battery cover of the main
unit, take the battery out, than disconnect the plug slightly. Connect the
plug of the new battery correctly, put the new battery in, and then x the
battery cover.
5.5 After using the machine or it is in need of charging, make the main
unit headon inserted in the pedestal and compress it to make sure the
main unit and pedestal chucking. When there is no need of charging,
please pull out the pedestal Adapter or put main unit into the pedestal
inversely.
6. Operation
6.1 Press the mode button to set the working mode, the corresponding
indicator will on when a mode set.
6.1.1 Full-power: the blue light radiates in full power.
6.1.2 Ramping: the blue light power increases stronger continually,
after 5 seconds reaches to the highest power.
6.1.3 Pulse: the blue light works on the pulse condition.
6.2 Press the time button to set the solidifying time, 4 working time is
available: 5, 10, 15, 20seconds.
6.3 When operating, aim the optical ber at the correct position, press the
power button to start or stop to emit of the blue light.
6.4 During operation, the blue light can be stopped by press the power
button at any time.
6.5 A battery detect circuit is xed inside the main unit, when low power
is detected, the indicator of the main unit will wink, please charge in
time.
6.6 Connect the Adapter and the charge device correctly, put the main
To Next Page
Loading...