7
2.0bar~2.3bar (0.20MPa~0.23MPa) before each use, other parts should
be cleaned by clean water or neutral sterilized liquid, but do not soak
the equipment in the water. Do not clean by volatile or soluble liquid,
otherwise the marks of the control panel will fade.
10.2 Please clean the optical fiber to avoid the remaining resin on the
surface and infect the life-span and the eectiveness of solidication.
11. Troubleshooting
Faults Possible causes Solutions
No indication
No response.
1. Battery is out of
power.
2. Faulty of battery.
3. Battery is protected.
1.Change a new
battery.
2. Change a new
battery.
3. Charge.
The screen shows
“Er”.
Faulty of main unit. Repair.
The screen shows
“E1”.
Low battery. Charge.
Light intensity is
weak.
1. The optical fiber is
not installed correctly.
2. There is crevice on
the optical ber.
3. There is resin on
the top of the optical
ber.
1. Reinstall the
optical ber.
2. Change a new
optical ber.
3. Clean the resin.
The equipment
doesn’t charge
when the adapter
is connected.
1. The adapter is not
connected well
2. Faulty of adapter or
incompatible.
3. The charging point
is impurity.
1. Reconnect.
2. Change the adapter.
3. Clean by the
alcohol.
To Next Page
Loading...