www.dtec.net.au 13
DYNertia3 Quick Start (Inertia- Chassis type)
Observing the engine data during a test
The available windows to view data in depend on the fitment of a second monitor.
Note: In inertia dyno mode the ‘Torque’ and ‘Power’ displays do not show data during a test, these are for analysing
data after a test. Keep this in mind when selecting suitable data to display on secondary screens
Due to limited screen space, with only a single monitor the data is
displayed as shown to the Left. There are chart recorders and
gauges for RPM, whilst the 4 data channels are displayed on a
second set of gauges with alarm limits.
If a multiple monitors are fitted then
there will be a dropdown list of possible
display Windows for the second monitor.
Note: Press the ‘GAUGES’ button to
turn second display on and off.
Below is a preview of the Windows available on a second monitor, please see main manual for full details.
To Next Page
Loading...