www.dtec.net.au 1
DYNertia3 Quick Start (Inertia- Chassis type)
‘Quick Start’ Guide for
Inertia Dyno- ‘Chassis’ Type
(see www.DTEC.net.au for ‘Quick Start’ guides on other dyno types)
‘Quick Start’ Guide: Version IC 8.2 (≥ V3.3.0)
DISCLAIMER: This software and hardware is provided "as is" without warranty of any kind, either express or implied, including, without limitation, any warranty of merchantability and fitness for a
particular purpose. In no event shall the creators of this software be liable for any direct, special, incidental or consequential damages arising out of the use or inability to use the software. The creators
and distributors of this software shall not be liable for any loss, damages or costs, arising out of, but not limited to, lost profits or revenue, loss of use of the software, loss of data or equipment, the costs
of recovering software, data or equipment or claims by third parties, damage to equipment, or other similar costs.
For continuous product improvement and due to ongoing development, we reserve the right to alter specifications without notice.
WARNING: This hardware and software is protected by law and international treaties. Unauthorized reproduction or distribution of Dynertia, or any portion of it, may result in severe civil and criminal
penalties and will be prosecuted to the maximum extent possible under law.
Dynertia software, hardware & firmware is copyright- Darren Todd 2022
To Next Page
Need help?
General
