www.dtec.net.au 2
DYNertia3 Quick Start (Inertia- Chassis type)
STOP !!!
Important notice
To be read in conjunction with the main manual!
The following ‘Quick Start’ guide contains basic information for
your Inertia dyno (chassis type)
This is a brief overview of some main operations, it builds the base
that will allow understanding of the features explained in the main
DYNertia3 manual.
Tip- There are sample test Runs installed along with DYNertia3 software so you can learn to use many of the features
without needing to perform actual ‘Runs’.
To Next Page
Loading...