www.dtec.net.au 6
DYNertia3 Quick Start (Inertia- Chassis type)
Basic wiring
Dyno only needs the USB and the speed sensor connected for use.
Example of wiring with some additional devices shown
Note: Until correct dyno operation is confirmed and some trial runs have actually been done –
# Do not connect any sensors to input terminals
# Do not connect anything to the “RPM Adapter” input, including the ‘RPM adapter’ (if you have one)
Please refer to the main DYNertia3 Manual (found under ‘Help’ menu) chapter called ‘Inputs- Using’ for full wiring details
on connection of optional data acquisition devices or ‘RPM Adapter’.
To Next Page
Loading...
