www.dtec.net.au 8
DYNertia3 Quick Start (Inertia- Chassis type)
Two Main DYNertia3 Windows (DYNO / GRAPH)
Press the “DYNO” / “GRAPH” button to change between the 2 main Windows of DYNertia3.
The ‘DYNO’ Window is used to select and create files, enter the weather details, record vehicle test data, ‘teach’ gear
ratios, view RPM/speed and control the testing.
Note: This Window is only visible when the control unit is connected, powered and ‘Linked’.
Note: The Row of gauges (input channel
data) shown along the bottom of the
screen are visible with a single monitor.
With duel monitors this data is displayed
on the second monitor instead and
replaced with the test ‘comments’ field
(also found in ‘View’ menu).
The ‘GRAPH’ Window displays the Power and Torque as traces that can be overlayed and analysed. Traces from a test
Run can be selected, loaded from file and compared.
Note: The ‘Setup’ menus (and most
menus) discussed in the following pages
are only accessible from this GRAPH
screen (they are ‘greyed’ out in DYNO
screen)
Note: The RPM/Speed button makes
the software use either units of RPM or
speed (e.g. kph) for the controls,
displays and graphs.
Note: When test Runs are visible on the
graph we refer to them as ’traces’.
Note: The DYNertia3 Window does not size itself to the PC screen, if you wish you can adjust your PC screen resolution
to best suit (Program Window size is1024 x 768)
To Next Page
Loading...