To Next PageTo Next Page
Need help?Do you have a question about the DTS ECO 500 and is the answer not in the manual?
Instructions for mounting the base plate for the gate motor.
Steps for correctly mounting the gearbox onto the base plate.
Procedure to enable manual control of the gate motor.
Guidance on attaching the gate rack to the gate leaf.
Instructions for installing limit switch actuators on the nylon rack.
How to connect a 16VAC transformer to the charger board.
Connecting a 220V transformer to the gate motor's PCB.
Diagram for connecting IR beams to the control board.
Setup for pedestrian access mode.
How to adjust the load pot for motor sensitivity.
Description of the main control board and its components.
Steps to program transmitters for full gate opening.
Steps to program transmitters for pedestrian access.
Procedures for individually or master erasing programmed transmitters.
Description of the gate operator's standard mode.
How to change the motor direction using a jumper.
Details on the automatic closing feature, including safety requirements.
Information on the pre-programmed pedestrian opening function.
Explanation of the different LED indications on the control board.
Table outlining common gate operator symptoms and their likely causes.
Recommended actions to resolve identified gate operator problems.
General| Brand | DTS |
|---|---|
| Model | ECO 500 |
| Category | Garage Door Opener |
| Language | English |
