EasyManua.ls Logo

DTS Dts-12 - User Manual

DTS Dts-12
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
Base plate-mounting instructions
Dts-12
ROLLER DOOR OPERATOR
INSTALLATION MANUAL
Comply to: SANS IEC 60 335-2-103
NRCS Cert. no. 88934/002
DTS SECURITY PRODUCTS CC
P.O.BOX 3399
EDENVALE
1610
TELEPHONE 086 1000 387
Spartan +2711 392 5540 (H/O)
Pretoria +2712 361 5528
Alberton +2711 907 8846
Natal +2731 916 4002
www.dtssecurity.co.za
Question and Answer IconNeed help?

Do you have a question about the DTS Dts-12 and is the answer not in the manual?

DTS Dts-12 Specifications

General IconGeneral
BrandDTS
ModelDts-12
CategoryGarage Door Opener
LanguageEnglish

Summary

Safety Precautions

Important Safety Rules

Essential safety guidelines for installation and operation to prevent injury.

Pre-Installation Notes

Side Clearance Requirements

Specifies minimum and recommended side clearance for operator installation.

Installation Considerations

Advice for retro-fitting, re-tensioning, and contacting suppliers for issues.

Installation Instructions

Krazi Door Installation

Steps for installing the operator on Krazi doors with >135mm drum clearance.

Wispeco Door Installation

Steps for installing the operator on Wispeco doors with <135mm drum clearance.

New Door Installation

Drive Unit Mounting

Steps for sliding the drive unit onto the shaft and engaging spokes.

Securing the Motor Assembly

How to clamp the shaft to mounting brackets and disengage the drive.

Setting Top and Bottom Limits

Limit Cam Adjustment

Step-by-step guide to adjust limit cams for door open/close positions.

Completing Limit Setting and Final Checks

Engaging Drive and Testing

Steps to re-engage motor, test operation, and fit cover plate.

Security Screw Installation

Instructions for fitting security screws for the curtain and drum wheel.

Control Box Setup and Configuration

Wiring and Dipswitch Settings

Explains wiring connections, auto-close, and hand installation dipswitch settings.

Transmitter Programming

Procedure for programming remote control transmitters to the control box.

Owners Manual

Door Operation Modes

Explains how to operate the door via transmitter or control box.

Key Features and Functions

Details manual operation, obstruction detection, courtesy light, auto-close, and photo-electric sensor.

Troubleshooting Guide

Control Box and Transmitter Issues

Diagnoses problems related to the control box or handheld transmitter not operating.

Door Operation Faults

Addresses issues like incomplete opening, reversing, hard stops, and remote range problems.

Power Failure and Technical Specifications

Manual Release Mechanism

Instructions on how to disengage/engage the motor during power failure.

System Specifications

Details input voltage, motor, control board, and transmitter specifications.

Warranty Information

Warranty Terms and Conditions

Outlines the 12-month factory warranty, exclusions, and claim procedures.

Related product manuals