5
NETIMPRESS avant is an electronic device which consists of high-precision
electronic components. Please be sure to understand and follow the caution
listed below in order to avoid any accidents and as well as to make the most of
your NETIMPRESS avant.
Note
Power On Sequence
Make sure to follow the switch ON/OFF order of each way of a host computer, NETIMPRESS
avant, and a target system.
The Switch ON / Switch OFF sequence should be followed in order to avoid major damages to a
target system and NETIMPRESS avant itself.
<Power On Sequence>
① Host computer
② NETIMPRESS avant
③ Target system
<Power Down Sequence>
① Target system
② NETIMPRESS avant
③ Host computer
Connecting the Probe and Connector
All probes and cables are designed to prevent an incorrect connection. Never force them to plug in nor
unplug. Confirm the position and direction.
Insertion and removal of the Cable
Be sure NOT to insert and remove the cable while NETIMPRESS avant is powered on. (Pay special
attention to the insertion and removal of the M12 cable between NETIMPRESS avant and the
adaptor.) Otherwise, it may cause a serious damage to NETIMPRESS avant and a target system.
Disassembling NETIMPRESS avant
Since NETIMPRESS avant contains printed circuit boards with minute patterns, never remove screws
or disassemble NETIMPRESS avant.
If the product is disassembled or modified by the user, it will not be covered under the warranty or
support services
Neutralization
Make sure to neutralize the charge before operating NETIMPRESS avant.
To Next Page
Loading...