Display normal orientation for
floor mounting position (Default)
Display inverted orientation for
suspended mounting position
Display stand-by disabled
(Default)
Display goes OFF after 10 seconds
Display forced OFF even if control
signal is missing or error messages
are shown.
Allows to select 10 DMX
channels mode (Default)
Allows to select “RGBA” mode (4
DMX channels).
Allows to select 6 DMX channels
mode.
Allows to select “FINE” mode (10
DMX channels).
Allows to select “PROM” mode (11
DMX channels).
Allows to select the value of the
delay (in milliseconds) for Dimmer
channel reaction to DMX or
Program variation.
Off = Instant response to DMX
variation.
4 = 100 ms Smooth response to
DMX variation (Default)
20 = 500 ms Smooth response to
DMX variation.
Allows to select Quadratic
current output for LED (Default).
Allows to select Linear light output.
Allows to set S-curve to emulates
light intensity characteristics of the
tungsten halogen lamps.
Allows to set gamma curve 2.2 .
Allows to adjust the PWM
frequency value (Hz) in order to
reduce flickering in the process of
your camera recordings.
Range = 610 – 5000 Hz
Default = 1000 Hz
Allows to increase the LED’s
current from 70% to 100%
Default = ON
To Next Page
Loading...
Need help?
General
