In DMX Recorder mode it is possible to create
and store the scenes of the CHPR menu by
using an external DMX controller.
The unit must be set to 10 DMX channels mode.
Refer to “REC MODE” for details.
Slave mode.
The unit is forced to DMX address 1 and 10
DMX channels mode receiving signal from the
unit set in Auto mode.
Allows to select the internal fans speed.
Standard mode: High fans speed.
Silent mode: Low fans speed for a very low
noise operation.
Default = SIL
No DMX action.
Keep last valid DMX signal (Default)
Chase with 16 steps previously created in REC
mode as per AUTO > CHPR menu.
Speed time and wait time values (in seconds)
selectable by user (Default = 10).
In Auto mode the unit do generate DMX for
slave units.
Custom.
RGBA, RGBA Fine, Dimmer and Dimmer Fine
values selectable by user.
(Default = 128).
Custom2.
RGBA, RGBA Fine, Dimmer and Dimmer Fine
values selectable by user only via PROM mode
or via RDM.
Custom3.
RGBA, RGBA Fine, Dimmer and Dimmer Fine
values selectable by user only via PROM mode
or via RDM
Custom4.
RGBA, RGBA Fine, Dimmer and Dimmer Fine
values selectable by user only via PROM mode
or via RDM
To restore default settings
LED temperature monitoring
Micro controller temperature monitoring
Outputs 1 and 2 of LED Driver board
temperature monitoring
Output 3 and 4 of LED Driver board temperature
monitoring
Shows the total unit life time and the RGBA
LEDs life time
To Next Page
Loading...
Need help?
General
