EasyManua.ls Logo

Dualit DCM1 User Manual

Dualit DCM1
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
With Coffee Machine turned off;
remove Water Tank and pour in the
full 150ml bottle of Kilrock Espresso
& Coffee Machine Descaler, followed
by water to fill tank to MAX mark.
Replace Water Tank on the machine,
plug in and turn on. Ensure the
Steam/Water Selector switch is set
to Water. Warning: Keep in this
setting throughout, never on Steam
mode. Risk of chemical inhalation.
Place a 1.5L heat resistant container
on the Drip Tray underneath the
Filter Holder, remove the Froth
Nozzle from the Steam Wand and
aim into the container. Dualit
recommend a minimum container
depth of 8cm to reduce splashing.
Caution: Do not remove the Drip
Tray.
Turn the Control Knob to Coffee for
approximately 45 seconds to run
through a quarter of water in the
tank. Empty your container before
step 5. Caution: Hot water.
Turn the Control Knob to the
Steam/Water position for
approximately 45 seconds until the
water level has dropped to half a
tank. Caution: Be aware of splashing
outside container when dispensing
hot water. May be harmful during
descale. Wait 10 minutes for
descaling to take effect. Then repeat
steps 4 & 5, to reach the minimum
water level in the Water Tank.
Empty your container, rinse and refill
the Water Tank with fresh water.
Repeat steps 4 & 5 twice, without
the 10 minute break. Flushing
through two full tanks of fresh
water removes traces of the
descaling solution.
Caution: Hot water.
Place an OSCAR Bag into the Water
Tank to soften your water and
reduce limescale build-up. Never
allow OSCAR Bag to come into
contact with descale solution.
For more information or to buy your
OSCAR Bag visit:
www.dualit.com/accessories
Refill the Water Tank with fresh
water, replace the Froth Nozzle back
onto the Steam Wand. Descale is
now complete.
You are now ready to make a coffee
or unplug the Coffee Machine and
follow the Cleaning Monthly
instructions in your manual.
Kilrock Espresso & Coffee Machine Descaler Instruction Manual For Espressivo/Coffee Machine (DCM1/DCM2/DCM2X)
IMPORTANT NOTICE: PRODUCT FAILURE DUE TO THE BUILD UP OF LIMESCALE IS NOT COVERED BY GUARANTEE. Dualit recommends descaling at least once a month, in a well-ventilated area, to prevent limescale
build up in the machine. The descale cycle will take approximately 45 minutes to complete. To prolong the life of your Coffee Machine and ensure it continues to produce consistent quality coffee, Dualit recommends
the use of an OSCAR Bag water softener. For more information, visit our website www.dualit.com/accessories or contact our Customer Services on 01293 652500 option 1.
1
2 3
4
5 6
7
8
GB-A
ACTIVE INGREDIENTS: Contains
amidosulphonic acid and
corrosion inhibitor. See additional
notes and instructions on main
box. KILROCK PRODUCTS LTD. Unit
1b Alma Road Industrial Estate,
Chesham, Bucks, HP5 3HB
Question and Answer IconNeed help?

Do you have a question about the Dualit DCM1 and is the answer not in the manual?

Dualit DCM1 Specifications

General IconGeneral
BrandDualit
ModelDCM1
CategoryCoffee Maker
LanguageEnglish

Summary

Espressivo/Coffee Machine Descaling (DCM1/DCM2/DCM2X)

Step 1: Prepare Descaler Solution

Pour full 150ml Kilrock descaler and water into the tank to MAX mark.

Step 2: Replace Tank and Set to Water Mode

Replace water tank, plug in, set Steam/Water selector to Water.

Step 3: Position Container and Aim Wand

Place container, remove Froth Nozzle, aim into container.

Step 4: Initial Water Dispensing Cycle

Run water for 45s until half tank, then repeat to minimum level.

Step 5: Steam/Water Position Run Cycle

Run water from Steam/Water position until half tank.

Step 6: Descaling Soak Period

Wait 10 minutes for descaling to take effect.

Step 7: Repeat Dispensing and Flushing

Repeat dispensing, then flush with two full tanks of fresh water.

Step 8: Final Rinse and Completion

Refill with fresh water, replace nozzle; descaling is complete.

Espress Auto Coffee & Tea Machine Descaling (DCM3/DCM3T)

Step 1: Prepare Descaler Solution

Pour full 150ml Kilrock descaler and water into the tank to MAX mark.

Step 2: Replace Tank and Remove Nozzle

Replace water tank, plug in, remove Froth Nozzle from Steam Wand.

Step 3: Position Container and Aim Wand

Place container, aim Steam Wand into container.

Step 4: Initial Water Dispensing

Press Tea button 3 times to run water, empty container.

Step 5: Hot Water Mode Run Cycle

Turn Steam Flow Control dial on for 1 min until half tank.

Step 6: Descaling Soak Period

Wait 10 minutes for descaling to take effect.

Step 7: Repeat Dispensing and Flushing

Repeat dispensing, then flush with two full tanks of fresh water.

Step 8: Final Rinse and Completion

Refill with fresh water, replace nozzle; descaling is complete.

Café Plus Descaling (CPD3)

Step 1: Prepare Descaler Solution

Pour full 150ml Kilrock descaler and water into the tank to MAX mark.

Step 2: Plug In and Place Mug

Plug in, switch on, place mug on drip tray under nozzle.

Step 3: Check Lever Position

Lift and lower lever to ensure no capsule is in the machine.

Step 4: Enter Descale Mode

Press and hold Coffee and Tea buttons for 5 seconds.

Step 5: Initial Water Dispensing

Press Coffee button to dispense water, stop after 1 min 10 sec.

Step 6: Descaling Soak Period

Wait 10 minutes for descaling to take effect.

Step 7: Repeat Dispensing and Flushing

Repeat dispensing, then flush with two full tanks of fresh water.

Step 8: Final Rinse and Completion

Refill with fresh water, press buttons to return to normal.

Café Cino Descaling (CPD3M)

Step 1: Prepare Descaler Solution

Pour full 150ml Kilrock descaler and water into the tank to MAX mark.

Step 2: Plug In and Place Container

Plug in, switch on, place 800ml container under nozzle.

Step 3: Check Lever Position

Lift and lower lever to ensure no capsule is in the machine.

Step 4: Enter Descale Mode

Press and hold Coffee and Tea buttons for 5 seconds.

Step 5: Nozzle Dispensing Cycle

Press Coffee/Tea button to dispense 500ml water from nozzle.

Step 6: Steam Wand Dispensing

Press Cappuccino/Latte button to dispense 200ml from steam wand.

Step 7: Descaling Soak and Flushing

Wait 10 mins, then rinse and flush with three full tanks of water.

Step 8: Final Rinse and Completion

Refill with fresh water, replace parts, press buttons to return to normal.

Classic Capsule Machine Descaling (CPD4)

Step 1: Prepare Descaler Solution

Pour full 150ml Kilrock descaler and water into the tank to MAX mark.

Step 2: Plug In and Place Container

Plug in, switch on, place 1.5L container under nozzle.

Step 3: Check Lever Position

Lift and lower lever to ensure no capsule is in the machine.

Step 4: Enter Descale Mode

Press and hold Coffee and Tea buttons for 5 seconds.

Step 5: Initial Water Dispensing

Press Coffee button to dispense water for 1 min 30 sec.

Step 6: Descaling Soak and Flushing

Wait 10 mins, then rinse and flush with two full tanks of water.

Step 7: Add OSCAR Bag

Place an OSCAR Bag into the Water Tank to soften water.

Step 8: Final Rinse and Completion

Refill with fresh water, replace parts, press buttons to return to normal.

Related product manuals