20
Dualtron X User Manual
1. Brake adjustment method
As you continue to use the brakes, the brake pads will become worn out
and the gap between the pads and the brake disc will become wider.
If the braking force drops, use a 5mm hexagon wrench to loosen the brake
arm wire bolt, then lift the brake arm upwards to adjust the braking force.
Important check list
3) Maintenance by self-maintenance
2. How to replace a tire
1. Remove the motor shaft nut (18 mm) after removal of the caliper
bracket and the brake caliper, and release the tightening bolt to
which the motor and wheel are connected.
2.
After deflating the tire, press the tire to separate it from the wheel.
3. After replacing the tire, complete the assembly of the tire in
reverse order. After assembly, apply a good fit to the main frame
and tighten the screws and bolts to secure.
※
•
After the tire has been replaced, run a simple test drive to match the pressure marked on the side of the tire.
•
Patch seal (worm) can be used for repair in case of a puncture. Use tires for continuous inspection and check.
* Metal vibration may occur due to motor vibration and the vibration of the brake disc and pad during the load
section that accelerates during driving. (About 15 ~ 30Km, different for each product)
This is a phenomenon in which all rotations (fans, automobiles, ships, etc.) are vibrating at a specific rotational
frequency (rpm) rather than the product.
However, if the continuous noise or metal noise is large, there is a possibility that the disk will become bent
and deformed.
* Please note that after running, there is a risk of burns due to the heat on the motor and brake (especially
disk rotor) side.
* Be careful that the bolts of the motor, rim, and motor shaft may become loosened due to the ABS function.
* For inspection and repair, remove the side cover, attach the power switch, and attach it with the product's
standard bolt. When tightening, carefully remove the cover of the wiring. Bolts other than the rule bolts (long
bolts) can cause serious damage to the battery casing (battery cells), which can cause fire or safety accidents.
※
Folding parts and joints where movement occurs due to product characteristics can naturally damage
the surface or paint surface during use, especially when operating in incorrect operation and form.
※
When inspecting the product, keep two wheels away from the ground and work on a safe workstation.
Important notice
Easywheel System
• Full removable hub motor design
By designing rims and hub motors to enable complete separation, we have greatly improved the
maintenance and maintenance of products by allowing only rims to be replaced without replacing the motor
in the event of rim failure (Patent pending).
To Next Page
Loading...
