CHECK BEFORE OPERATION
Be sure of what you are pumping. This pump is designed to pump only fresh water
that is not intended for human consumption.
For your safety, and to maximize the service life of your equipment, it is very
important to take a few moments before you operate the pump to check its
condition. Be sure to take care of any problem you find, or have your servicing
dealer correct it, before you operate the pump.
Improperly maintaining this pump, or failing to correct a
problem
before operation, could cause a malfunction in which you
could be seriously injured.
Always perform a pre-operation inspection before each operation, and
correct any problem.
Exhaust gas contains poisonous carbon monoxide. Avoid inhalation of exhaust gas.
Never run the engine in a closed garage or confined area.
To prevent fire hazards, keep the pump at least 3 feet (1 meter) away from building
walls and other equipment during operation. Do not place flammable objects cl
ose to
the engine.
Before beginning your pre-operation checks, be sure the pump is on a level
surface and the ignition switch is in the OFF position.
Check the General Condition of the Pump
Look around and underneath the pump for signs of oil or gasoline leaks.
Remove any excessive dirt or debris, especially around the engine muffler, and
recoil starter.
Look for signs of damage.
Check that all nuts, bolts, screws, hose connectors and clamps are tightened.
Check the Suction and Discharge Hoses
Check the general condition of the hoses. Be sure the hoses are in serviceable
condition before connecting them to the pump. Remember that the suction hose must
be reinforced construction to prevent hose collapse.
Check that the sealing washer in the suction hose connector is in good condition .
Check that the hose connectors and clamps are securely installed .
Check that the strainer is in good condition and is installed on the suction hose .
7
To Next Page
Loading...
