45
E
2) Move the cold start lever (1) to (B) (fig. 38).
3) Check that the stop switch (2, fig. 39) is positioned to
(RUN), then press the starter button (3).
Let the engine start without using the throttle control.
Important
Never operate the electric start button more than 5
seconds at a time. If needed, allow 10 seconds before
attempting to restart the engine.
4) Slowly move the cold start lever (1) to its vertical
position (A) (fig. 38).
Important
Do not rev up the engine when it is cold. Allow
some time for oil to reach all points that need lubricating.
High ambient temperature (over 35 °C/95 °F):
Follow the same procedure for “Regular ambient
temperature”, however, do not use the device (1, fig. 38).
Cold ambient temperature (below 10 °C/50 °F):
Follow the procedure for “Regular ambient
temperature”, however allow 5 minutes for the engine to
warm up.
To Next Page
Loading...
