EasyManuals Logo

Dunkirk XEB-4 Installation Instructions

Dunkirk XEB-4
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
PRODUCT LITERATURE
MODELS
XEB-2
XEB-3
XEB-4
XEB-5
XEB-6
XEB-7
This boiler cannot be used with all types of
chimneys. Read these instructions carefully
before installing.
These Gas-Fired Hot Water Boilers are low pressure, sectional cast
iron boilers Design Certified by C.S.A. (Canadian Standards
Association) for use with Natural and Propane Gases. They are
constructed and hydrostatically tested for a maximum working pressure
of 50 psi in accordance with A.S.M.E. Boiler and Pressure Vessel
Code Section IV Standards for cast iron heating boilers.
INSTALLATION INSTRUCTIONS
These instructions must affixed on or adjacent to the boiler.
Gas-Fired
Hot Water
Induced Draft
BOILERS
DUNKIRK BOILERS
DUNKIRK, NEW YORK 14048 - AREA CODE 716 366 - 5500
MEMBER: The Hydronics Institute
XEB
SERIES
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury
or property damage. Refer to this manual. For assistance or information consult a qualified installer,
service agency or the gas supplier.

Other manuals for Dunkirk XEB-4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dunkirk XEB-4 and is the answer not in the manual?

Dunkirk XEB-4 Specifications

General IconGeneral
BrandDunkirk
ModelXEB-4
CategoryBoiler
LanguageEnglish

Related product manuals