Check to be sure you have the right size boiler before
starting the installation. See rating and capacity table
on previous page. Also be sure the new boiler is for
the type of gas you are using. Check the rating
plate on the right side of the boiler.
You must see that the boiler is supplied with the
correct type of gas, fresh air for combustion, and
a suitable electrical supply. Also, the boiler must
be connected to a suitable chimney or horizontal
venting system and an adequate piping system.
Finally, a thermostat, properly located, is needed
for control of the heating system. If you have any
doubts as to the various requirements, check with
local authorities and obtain professional help where
needed. Take the time to complete all of the steps
for SAFE and PROPER operation of the heating
system.
If this boiler is installed in a building under
construction, special care must be taken to insure
a clean combustion air supply during the
construction process. Airborne particulates such
as from drywall dust and from fiberglass insulation
Before You Start
KEEP BOILER AREA CLEAN AND FREE FROM COMBUSTIBLE MATERIALS, GASOLINE
AND OTHER FLAMMABLE VAPORS AND LIQUIDS
Installers - Follow local regulations with
respect to installation of CO detectors. Follow
maintenance recommendations in this
instruction manual.
Techniciens - Veuillez vous conformer á la
réglementation en vigueur concernant Í
installation des détecteurs d oxyde de
carbone. Suivre les consignes dentretien
figurant dans le manuel dinstruction cijoint.
can clog the burner ports
and cause incomplete
combustion and sooting. Where required by the
authority having jurisdiction, the
installation must
conform to American Society of Mechanical Engineers
Safety Code for Controls and Safety Devices for
Automatically Fired Boilers, No. CSD-1*
The installation must conform to the requirements of
the authority having jurisdiction or, in the absence of
such requirements, to the National Fuel Gas Code,
ANSI Z223.1-latest revision.
In Canada, the boiler shall be installed according to
CSA-B149.1 and .2, Installation Code for Gas Burning
Appliances and Equipment.
2
To Next Page
Loading...
