25
ENGLISH
DUOTONE SLICK 23 / SLICK 23 MANUAL
BLADDER REPAIR
3. Pull carefully on the line coming out of the middle of the leading edge and feed the bladder back
into the cavity.
4. Be sure that it is inserted correctly without twisting.
5. When the bladder is completely inserted, make sure that the air valves are positioned correctly in
the valve opening.
6. Screw the secure ring back onto the valve.
7. Re-attach the rubber hoses to the leading edge valves.
8. Close all lazy-pump-cleats.
9. Fill the leading edge with air carefully.
10. Check that the bladder has been correctly inserted and look for wrinkles in the material. If you
detect any irregularities in the air tube or if the valve is not positioned correctly, deflate and start
over again.
11. Roll up the excess bladder and close the flaps at the wing tips.
To Next Page
Loading...
