~36~
2
After the first notching process, the clamp station will remain to
the left side of DB-280 and the LED display of the control panel
will display and flash "LOAD COVER".
3
Center the cover sheet and adjust the side guide:
Measure the width of the book plus half the thickness of the
spine. Then set side guide accordingly.
4
Place the cover on the nipping station, the “START” LED will
be lit and flashing "PUSH START". Then press the “START”
button to move the clamp station over the nipping station
starting the binding process for the book block and cover sheet.
Note:
If you accidentally remove or drop the cover sheet during the
clamping station returning to the nipping station, the control
panel will show “COVER?”. At this moment, you have to place
the cover on the nipping station and press "START" button to
resume the process.
5
When the display indicates “PUSH OPEN”, press the “OPEN”
button to open the clamps. Then, remove the finished book from
the right end of the clamp station.
Having completed one bound book, the LED display of control
panel will count once for the total binding amount as shown.
Then the control panel will display and flash "LOAD BOOK"
for binding next book.
6
Repeat step 1 to 5 for more books in “MANUAL” operation.
To Next Page
Loading...
Need help?
General
