Duplo DP - M300

78
Replacing the Master Ejection Core
The message “EXCHANGE EJECT ROLL” is displayed on the LCD panel when the master ejection core is full.
Remove the master ejection core using the following procedure:
• Use only a master ejection core designed for use in this machine.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the master ejection box r
elease lever to open
the master ejection box.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Open the master ejection box until it stops.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Open the cov
er while pressing and holding the
master ejection box lid release lever.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Master ejection box
lid release lever
EXCHANGE
EJECT ROLL
IMPORTANT
Master ejection box release lever