210
c HELP Mode Function and Operation Procedures
chap.7
(4)
Adjusting/Checking the Drum Section
(4 pages in total)
Page 4 :
2
Adjusting the master detach position.
Normally, adjustment is not made.
¡ Operation procedure
4.
2
Normally, adjustment is not made.
Adjusting the master detach position.
3.
2
Press the
(MASTER MAKING)
key.
Every time this key is pressed, the drum stops at the
master detach
position.
Check operation.
1.
Check that the master is wound around the drum. Then enter
“
005
”
by the
NUMERIC
keys and then press the
(PRINT)
key.
Call the HELP mode
“
H-005
”
.
2.
Touch the
(
arrow
)
on the screen lower right three times to switch to
Page 4.
Change the screen.
a
To exit the HELP mode
: Turn the power switch OFF.
a
To access another HELP mode
:
Enter the desired mode number
using the numeric keys.
5.
Press the (STOP) key.
The HELP mode selection display will reappear.
Return to the HELP mode.
To Next Page
Loading...