Dupray Neat - Filling and Refilling the Boiler; Initial Water Filling Procedure; Refilling During and After Use

6
FILLING WITH WATER
REFILLING DURING/AFTER USE
Important: To avoid burns from escaping steam
when removing the boiler cap:
Repeat steps for filling with water.
Unscrew and remove the boiler cap
10
.
Press and hold the steam trigger
4
to release all the remaining steam.
Allow 20 minutes for the
unit to cool down.
Put the boiler cap
10
back on tightly.
Pour water in the boiler until it’s full.
Max: 40 oz. (1200 ml)
Never put anything else than clean water
in the boiler.
Tips: • Using demineralized water prevents mineral
build up and prolongs the life of the unit.
• Hold the steam trigger during refills
to make it faster.