Dura Trel 11127 User Manual

Dura-Trel, Inc. ~ PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020
#11127 4’ KIDS PICNIC TABLE
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED:
Drill with #2 Phillips Bit,
¼" and 3/32" Drill Bits
2 – 7/16” Wrenches or Sockets
File
TABLE TOP ASSEMBLY
(Refer to Upper Portion of Drawing 1)
On a large flat non-abrasive surface lay the four 1½ x 5½ x 48" table top rails with pilot holes for
screws facing up. (Table top rails have pilot holes farthest from the ends of the rail.) Set the two
20" brackets over the pilot holes on each end of the table top rails, leaving a ⅛” gap between rails.
Fasten one bracket to rails with ¾” screws. Repeat for other end of table.
Apply glue to the inside edges of the ⅞ x 1½ x 22⅜" end cap and push (do not slide from end) the
end cap onto the end of each table top, taking care that the end cap is flush with the outer edges of
table top.
SEAT ASSEMBLY
(Refer to Lower Portion of Drawing 1) (Make 2)
Lay out 2 pieces of seat rail with pilot holes facing up and an approximate gap of ⅛" between them.
(Seat rails have pilot holes closest to the ends of the rail.) Place an 8¾" bracket over pilot holes on
one end of the seat rails and fasten bracket to rails with ¾” screws. Repeat on other end of seat.
Apply glue to the inside edges of the ⅞ x 1½ x 11⅛" end caps and push onto the ends of the seat
rails.

Dura Trel 11127 Specifications

General

Brand	Dura Trel
Model	11127
Category	Outdoor Furnishing
Language	English

Summary

Table Top Assembly

Table Top Assembly Steps

Assemble table top rails using brackets and end caps, ensuring proper alignment and glue application for a secure fit.

Seat Assembly

Seat Assembly Steps

Assemble seat rails using brackets and end caps, ensuring correct gap and secure fastening with glue and screws.

Table Leg Assembly

Table Leg Assembly Steps

Construct leg assemblies by attaching cross rails to leg rails using bolts, washers, and nuts, applying glue to end caps.

Completing Table Assembly

Attaching Leg Assemblies

Attach completed leg assemblies to the underside of the table top using bolts, washers, and nuts.

Diagonal Brace Installation

Diagonal Brace Installation

Bolt diagonal braces to leg assemblies and the tabletop center using bolts and screws for added stability.

Seat Attachment

Seat Attachment

Attach seat rail assemblies to the leg assemblies' cross rails using bolts, washers, and nuts.

Final Finishing Notes

Edge Finishing

File or sand sharp edges on end caps after assembly to prevent cuts and scrapes.

Packing List

Parts Contained

Lists all parts and quantities included in the picnic table kit for assembly verification.

Hardware Bag Contents

Details the hardware items and quantities provided in the hardware bag for assembly.

Product Warranty

Warranty Coverage and Exclusions

Outlines what the warranty covers (manufacturing defects) and conditions not covered (abuse, improper installation, shipping damage).

Warranty Claims and Remedies

Details the process for making a warranty claim, the remedy provided (replacement), and the timeframe for reporting defects.