Dura Trel 11130 User Manual (English)

To Next Page

Dura-Trel, Inc. ~ PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020

SEAT ASSEMBLY

(Refer to Drawing 1)

Lay the two 48” seat rails on clean, flat surface with pilot holes facing up. Set the brackets over

pilot holes in rails, with the flanged side of the bracket toward center of seat. Fasten brackets to

seat rails with ¾” screws. Slide end caps over ends of seat, end caps will slide between bracket and

rails. You may apply household glue to inside of end cap if needed.

Place planter seat between two planter boxes by setting brackets over the edge of both planters.

If you encounter missing or defective parts, please contact manufacturer direct at

toll free # below.

#11130 PLANTER SEAT

ASSEMBLY INSTRUCTIONS

TOOLS NEEDED

Drill with #2 Phillips Bit or

Phillips Screwdriver

Super or Crazy Glue (optional)

Need help?

Do you have a question about the Dura Trel 11130 and is the answer not in the manual?

Dura Trel 11130 Specifications

General

Lists required tools such as drills, Phillips bits, and optional glue for assembly.

Assembling seat rails with brackets and end caps using screws and optional glue.

Positioning the assembled planter seat between planter boxes using the brackets.

Lists conditions not covered by the warranty, including misuse, improper installation, and environmental damage.

Outlines the process for making warranty claims and the manufacturer's remedies.

Details manufacturer's right to change designs and limitations on liability for damages.