t-
Symptom Remedy
No power.
1.The battery is depleted, please recharge the battery or use
the AC adaptor or car adaptor, make sure the AC outlet has power.
2.The fuse in the car adaptor is blown. To change the fuse,
unscrew the tip, replace only with same 3A 250V fuse.
3.The POWER switch is at the OFF position, please slide it to ON.
Battery is fully charged The battery protective circuit may have shut down the battery
but does not work. for safety. To reactivate the battery, charge it for a while.
Battery drains too fast The set continues to be on even in stop mode. If you plan on
in stop mode. leaving the disc stopped for a longer time, turn the set's power
off to conserve battery power or use the AC adaptor.
• Play fails to start even
when PLAY is pressed.
• Play starts but then
stops immediately.
No image on the LCD
screen.
No picture on your
external TV's screen.
The picture is distorted.
1.The disc may be damaged or scratched.
2.This player cannot play a DVD disc other than region 1 standard.
3.The disc may be dirty and may require cleaning.
4. Ensure that the disc is installed with the label side up (facing you).
5. If your disc is rented, it may be scratched or damaged from a
previous renter. Return it or polish it.
6. Condensation may have formed on your disc. Wait about 1
hour to allow the player to dry out.
The player's LCD may be turned off (as when you are using the
external TV).
1. Press the little button marked SCREEN OFF #12 on page 4.
2. Press and hold the SCREEN ON/OFF button on the remote.
1. Ensure that the equipment is connected properly. Double
check all cables and AC power.
2. Select the proper video channel on your TV set, VIDEO 1,2, 3, etc.
3. Check if the proper AV input is selected on your TV set video
inputs (some TV sets have 3 or 4 different inputs).
4. Make sure both the TV and DVD player are on.
1. Picture is distorted during rapid advance or rapid reverse. The
picture may be somewhat distorted occasionally, this is normal.
2. Did you connect your DVD player to your VCR? Please
connect the player directly to your TV and disconnect the VCR.
This player has Macrovision copy protection, this will distort
pictures when used with VCRs.
Some lines appear on
the screen during the Please turn the unit off and turn it on again after the vehicle is
startup of the vehicle, running.
The picture seems
squeezed or stretched.
The LCD mode and TV type you are in may be wrong for this
movie, try changing the LCD and TV type setting for standard
or widescreen. See pages 20 & 21.
--24-- IB-PDV709-WM-E-061006
To Next Page
Loading...