25
above 15 V DC. This may lead to accumulations of
hydrogen, causing exposure to fi re and explosion hazard.
CAUTION
Do not operate AC or DC appliances while the Duracell
®
Powerpack is being recharged with the DC charging cable
from your vehicle.
To recharge the Duracell
®
Powerpack while you drive using
the DC charging cable:
1. While the vehicle engine is running, plug one end of the
DC charging cable into a DC power outlet on the Duracell
®
Powerpack.
2. Plug the opposite end of the DC charging cable into the
vehicle’s lighter socket or 12 V accessory outlet.
3. Once the Duracell
®
Powerpack is fully charged or if your
vehicle’s engine is not running, disconnect the DC charging
cable from both sockets.Most of the Duracell
®
Powerpack’s
capacity will be restored in 2 ½ hours while the vehicle engine
is running.
Note: The Battery Level LEDs are only accurate when
the Duracell
®
Powerpack has been disconnected from all
appliances and all charging sources for 15 minutes.
Important: Do not leave the Duracell
®
Powerpack
permanently connected to the vehicle’s lighter socket or
12 V accessory outlet. Do not solder or hard wire the DC
charging cable from the Powerpack to an external electrical
system.The charging cable is designed for temporary use
To Next Page
Loading...
