Duracell Powerpack 300 - Recharging from a Solar Panel; Recycling

27
of 2.5 A (or 30 W) can be used to charge theDuracell
®
Powerpack
through the AC charger Input socket. You will need to purchase
a standard 5.5 mm OD × 2.5 mm ID (0.217 × 0.10”) coaxial DC
(barrel type center positive) connector to mate with the AC charger
input socket.
To wire the coaxial DC connector:
1. Connect the solar panel’s red positive (+) wire to the coaxial
plug’s inner or center contact.
2. Connect the solar panel’s black negative (–) wire to the plug’s
outer contact. See Figure 4-1.
Figure 4-1 Typical DC Coaxial Connector Connection
Once the connector is inserted into the AC charger input socket
and the solar panel is placed in the sun, the Duracell
®
Powerpack
charges automatically just as with the AC charger. See
“Recharging with the AC Charger” on page 23.
It takes about six hours in direct sunlight to recharge the Duracell
®
Powerpack from a 2.5 A solar panel.
Recycling
If it’s rechargeable, it’s recyclable!
Battery-Biz is committed to environmental responsibility and has
established a program for recycling Duracell rechargeable battery-