10
7. With the chocking and timber blocking still in place, from a posi-
tion on the ground, under the chassis frame, shift the control valve,
at the valve location, into the "Lower" position. If the valve is
spring centered, wire or lock the valve in the "Lower" position.
8. To prevent injury or death, move out from under the truck chas-
sis and clear all people from the area where the raised body could
potentially overturn. Use the crane mechanism to slightly raise
the dump body to relieve the pressure from the body supporting
timbers. Be sure the crane lifting device is securely attached to the
body and that both the crane and body are stable before removing
the body supporting timbers. Remove body supporting timbers,
being sure not to place your body or limb between the dump body
and chassis frame.
9. Using the crane, slowly lower the body in a controlled manner until
it is resting on the chassis frame.
10. Proceed to perform the repairs or replacement necessary to correct
the control mechanism failure, or other malfunction, by qualied
and trained personnel, such as your authorized DuraClass Distribu-
tor.
IF PROPER EQUIPMENT IS NOT AVAILABLE OR IF
YOU ARE INEXPERIENCED IN PERFORMING THE
ABOVE, DO NOT ATTEMPT TO LOWER THE BODY
OR ATTEMPT REPAIRS. IN EITHER CASE GET EX-
PERIENCED HELP AND PROPER EQUIPMENT BE-
FORE PROCEEDING. IF YOU SHOULD HAVE ANY
QUESTIONS CONCERNING ANYTHING CONTAINED
IN THESE INSTRUCTIONS, PLEASE CONTACT
DURACLASS FIELD SERVICE DEPT. (414) 647-3289.
To Next Page
Loading...