Durafly GLOSTER GLADIATOR MK1 - Control Throws; Decal Application Guidelines

The Gladiator Mk1 handles very well in flight, and that’s not down to good design alone, but a good
pre-flight set-up too. Before you fly your Gladiator please follow the recommended settings below
for optimum handling and performance.
Applying the supplied decals will take you longer than assembling the model. This is because great
care must be taken when doing so. Please follow carefully the guidelines below to achieve the best
possible finish on your Gloster Gladiator.
CONTROL THROWS:
DECAL APPLICATION GUIDELINES:
Elevator
- mm
- mm
- mm
- mm
mm
- mm
- mm
Aileron
Rudder
*Elevator ‘low rates’ mm ‘high rates’ mm in either direction from neutral.
*Rudder ‘low rates’
mm ‘high rates’ mm in either direction from neutral.
*Aileron ‘low rates’
mm ‘high rates’ mm in either direction from neutral.
10