Nice studio image of sPITFIRE here.
10. Install you choice of 6 channel receiver (Orange X620 shown) in approximately the area shown
below. Ensure all wires are held away from the servo horns. Also shown is the exact location
of a 40C 2200mah 4S lipo (as far forwards as possible) to achieve the correct CG as detailed
in the following pages.
Note: The fuselage LED shares a Y-lead with the gear servo from the wing. Be sure to
connect the LED lead before attaching the wing.
Congratulations, basic assembly of your Spitfire Mk1a
is now complete. Please perform a final check
on all screws, bolts and components,
ensuring all are secure and firmly in place.
6
To Next Page
Loading...
